Mounting arm for uneven ducts for DCON-DC700 detection camera.

Pipe for the duct detector DCON-DC700. 1,5 meters length for big size ducts.

Ventilation duct detectors installation camera. Compatible with all conventional and addressable Detnov detectors. IP54. Detector and base not included. Sampling pipe length: 600mm. Dimensions: 180 x 253 x 183 mm.

Indicator light with buzzer. 24Vdc power supply required. High brightness LED lighting. Polycarbonate case with transparent front. White color. Included “EXTINGUISHING SYSTEM ACTIVATED” label. CPR certificate EN54-3.

Compact carbon monoxide detector with electrochemical cell. Antivandal protection (wall fastening, shock resistance, protection against water). Connection to 2 wires without polarity. Diagnostic LED. Resolution: 1 ppm. Certificate UNE 23300: 1984. Dimensions: 93 x 93 x 55 mm. Ten years life time.

Standard carbon monoxide detector with electrochemical cell with deep base included. Connection to 2 wires without polarity. Diagnostic LED. Resolution: 1 ppm. Certificate UNE 23300: 1984. Dimensions: 77×100 mm. Ten years life time.

Carbon monoxide control panel of 2 zones expandable up to 3 zones. 32 detectors per zone. 2-wire installation without polarity, maximum distance of 2 km. 3 programmable level relays (extraction 1, extraction 2 and alarm). The relays can be configured for activation with a fault. Two shooting modes, standard (by value of each detector) or by the real average of the whole area. Test mode for the maintenance of the installation. Optional: TRMD-500 or TRMD-501 card allows the control of a speed controller connected to an engine achieving energy efficiency and reducing noise and vibrations. Housing made of ABS plastic, with possibility of being recessed. Dimensions: 439 x 268 x 112 mm. Power supply at 230 Vac. Certificate UNE 23300: 1984.

FS5200E is already certified by EVPU!!!

The Fire Extinguishing Control Panel is designated for fire protection, monitoring and control of systems for active extinguishing – gas, powder, aerosol, water, etc. After processing the signals from the automatic fire detectors and/or manual call points the Control Panel makes commands to the executive devices for extinguishing, sound-light signalers, air conditioning and ventilation devices, etc. The Control Panel could exchange data with a repeater, PC or another intelligent device via RS 485 interfaces.

Functional data
– Control of the lines, the controllable inputs and outputs for Fault condition and automatic resetting
– Control of the lines for removed fire detector and automatic resetting
– Option for setting the evacuation time from 0 to 5 minutes
– Option for setting the time when the extinguishing device is switched on from 10 seconds to 5 minutes
– Built-in sounder for Fire condition and Fault condition with the option for switching off
– Built-in clock for astronomic time
– Test modes and setting option
– Power independent archive of 100 events registered by the Control Panel, containing the type, date and time of the event